Publish Time: 2022-05-24 Origin: Site
The Shrink wrapping machine is highly automated equipment, which is widely used in medicine, food and beverage, household chemicals, and other industries. So, let's take a look at the precautions for installing and repairing Shrink wrapping machines. Here are some answers.
Here is the content list:
l Eight points to know about installing a Shrink wrapping machine.
l Precautions for maintenance of Shrink wrapping machine.
First, the Shrink wrapping machine and the winding machine consume a lot of power, so the input power must be greater than the nominal power on the nameplate of the Shrink wrapping machine, otherwise, it is easy to burn the circuit or electrical components. Second, the Shrink wrapping machine must be grounded reliably like a packer to protect personal safety. Third, the machine must be installed horizontally, otherwise, the service life of the electric heating tube will be shortened. Fourth, when the Shrink wrapping machine has been used continuously for more than three months, the temperature-resistant wires in the shrink room should be inspected and replaced according to the degree of aging. Fifth, when the machine is working, the palm of the operator and other parts are not allowed to come into contact with the running parts of the machine, especially since the temperature inside the shrinking chamber is extremely high and it is easy to burn. Sixth, after the packaging work is over, the heating switch should be turned off first, and the conveying motor and fan motor should continue to run for about 10 minutes, and then cut off the entire power supply.
First, the Shrink wrapping machine should be used in an environment where the temperature is -10℃-50℃, the relative humidity is not more than 85%, and there is no corrosive gas in the surrounding air, no dust, and no explosive hazard. Second, to ensure the normal operation of the vacuum pump for the Shrink wrapping machine, the vacuum pump motor is not allowed to reverse. The oil level should be checked frequently. The normal oil level is 1/2 to 3/4 of the oil window. Third, the impurity filter should be removed and washed frequently. Generally, it is cleaned once every 1 to 2 months, and the cleaning time should be shortened such as packaging debris. Fourth, the Shrink wrapping machine is not allowed to be placed at an angle or bumped during transportation, let alone to be placed down for transportation. Fifth, check decompression, filtration, and oil mist frequently to ensure that there is oil in the oil mist and the oil cup, and there is no water in the filter cup. Sixth, the heating strip and the silica gel strip should be kept clean and there should be no foreign matter sticking to it, so as not to affect the quality of the sealing. Seventh, the second layer of paste on the heating rod and under the heating plate serves as insulation. When it is damaged, it should be replaced in time to avoid short circuits. Eighth, the user prepares the working air source and inflation air source. The working pressure of the shrinking machine has been set to 0.3MPa, which is more appropriate. Do not adjust too much unless there are special circumstances.
If you want to learn more about our company or engage in work related to the Shrink wrapping machine, you can communicate with us on the website. Our official website is https:// www.alpsmachine.com/.